2-1Henny Penny Model OE-100SECTION 2. MAINTENANCE2-1. INTRODUCTION This section provides procedures for checking and replacement of thevarious parts u
Henny Penny Model OE-1002-102-10. FUSESTo avoid electrical shock or other injury, before startingthis procedure, move power switch to the OFF position
2-11Henny Penny Model OE-1002-12. FILTER HEATERSWITCHCheckoutThe Filter Heater Switch is a rocker type switch. With the switchin the "ON" po
Henny Penny Model OE-1002-122-13. FILTER HEATER593This unit is equipped with a strip heater in the event solidified shorten-ing accumulates in the fil
2-13Henny Penny Model OE-1002-14. FILTERING SYSTEM The filtering system consists of the filter valve, motor and filter pumpassembly, filter screen ass
Henny Penny Model OE-1002-142-15. FILTER VALVE The filter valve is a 3/8 inch two-way stainless steel ball valve. If thisvalve should develop leaks th
2-15Henny Penny Model OE-1002-16. FILTER PUMPREPAIR (Continued)3. To reassemble, place rotor on drive shaft, and place rollers intorotor.NOTEA small a
Henny Penny Model OE-1002-162-18. PUMP AND MOTORREPLACEMENT1. To replace the pump and motor assembly, insure the main powerhas been removed from the f
2-17Henny Penny Model OE-1002-19. COOLING FANMAINTENANCE(Continued)5. Close door and turn power switch on. Unit is now ready foroperation.If the fan n
Henny Penny Model OE-1002-18994
2-19Henny Penny Model OE-1001197
Henny Penny Model OE-1002-22-4. THERMAL SENSOR The thermal sensor determines the shortening temperature. If a mal-function does occur, an E6 will be d
Henny Penny Model OE-1002-201197
2-21Henny Penny Model OE-100694
Henny Penny Model OE-1002-221294
2-3Henny Penny Model OE-1002-5. HIGH TEMPERATURELIMIT CONTROLThe high temperature limit control is a manual reset control whichsenses the temperature
2-4Model OE-1004092-5. HIGH TEMPERATURELIMIT CONTROL(Continued)Before following these steps, place POWER switch in theOFF position and unplug the powe
2-5Henny Penny Model OE-1002-6. HEATING ELEMENTSNOTEHeating elements are available for 208 and 480 voltage.Check the data plate to determine the corre
Henny Penny Model OE-1002-62-6. HEATING ELEMENTS(Continued)1091Replacement1. Drain the shortening from the frypot.2. Remove the heating element wire f
2-7Henny Penny Model OE-1002-7. CONTACTORSThe following checks are performed with the wall circuitbreaker closed and the Power switch in the ON positi
Henny Penny Model OE-1002-82-8. FAN The Henny Penny OE-100 has a fan in the circuit which operates onlywhen the power switch is in the COOK position.
2-9Henny Penny Model OE-1002-8. FAN (Continued) 2. Label and disconnect fan motor wires.3. Remove the four screws, washers, and nuts securing the fan
Kommentare zu diesen Handbüchern