Henny Penny OFG-390 Bedienungsanleitung

OPERATOR’S MANUALHenny PennyOpen FryerModel OFG-390

Model OFG- 390SECTION 2. INSTALLATIONThis section provides the installation and unpacking instructions forthe Henny Penny OFG-

Model OFG- 3907. Remove the counterweights from the pallet, which arestrapped to the pallet, under the fryer.Do not drop. The co

Model OFG- 390Optional Ramp Unloading703

Model OFG- 3902-4 908

Model OFG- 3902-3. SELECTING THE The proper location of the fryer is very important for operation, LOCATION speed, and co

Model OFG- 3902-5. VENTILATION OF FRYER The fryer should be located with provision for venting intoadequate exhaust hood or vent

Model OFG- 3902-6. GAS SUPPLY • The fryer must be isolated from the gas supply piping (Continued) system by closing i

Model OFG- 3902-8 303

Model OFG- 3902-7. GAS LEAK TESTPrior to turning the gas supply on, be sure the gas valveknob on the gas control valve is in the

Model OFG- 3902-9. ELECTRICAL The gas fryer requires 120 volt, single phase 60 Hertz, 10 REQUIREMENTS amp, 3 wire groun

Model OFG- 390BOIL-OVER PREVENTION IN HENNY PENNY FRYERSFAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN SHORTENINGOVERFLOWING

Model OFG- 3903-1. OPERATING COMPONENTSPower/Pump Switch A three way switch with center OFF position; move the switch tothe posi

Model OFG- 3903-1. OPERATING COMPONENTS (Continued)High Limit This high temperature control senses the temperature of the

Model OFG- 3903-2. LID OPERATION To close lid:1. Lower the lid until latch comes into contact with the pot.To open lid:1. Unlatc

Model OFG- 3903-4. SWITCHES AND INDICATORSDrop Indicator The display reads “DROP” when the shortening has reachedthe setp

Model OFG- 390SMS ControlsTEMPERATURE BUTTON DIGITAL DISPLAY PRODUCT BUTTONSFigure 3-2303 3-5

Model OFG- 3903-5. FILLING OR ADDINGSHORTENINGThe shortening level must always be above the heatingelements when the fryer is he

Model OFG- 3903-6. BASIC OPERATION Follow the procedure below on the initial start-up of the fryer, andeach time the fryer is b

FM05-031-ERevised 8-6-10LIMITED WARRANTY FOR HENNY PENNY EQUIPMENTSubject to the following conditions, Henny Penny Corporation makes the following lim

Model OFG- 390 3-6. BASIC OPERATION 4. Allow fryer to heat until digital display shows “DROP”. (Continued) (Press the EX

Model OFG- 3903-7. CARE OF THE SHORTENINGFOLLOW THE INSTRUCTIONS BELOW TO AVOIDSHORTENING OVERFLOWING THE FRYPOT,WHICH CO

Model OFG- 3903-8. FILTERING OF SHORTENING (continued)ONLY FILTER WHEN “COOL” IS DISPLAYED.FAILURE TO DO SO CAN RE

Model OFG- 3903-8. FILTERING OF 5. Scrape cracklings and crackling ring from frypot and discard. SHORTENING Do not let crack

Model OFG- 3903-10. LIGHTING AND To light burner: SHUTDOWN OF THE 1. Turn POWER/PUMP switch to the OFF position. BURNE

Model OFG- 3903-11. CLEANING THE FRYPOT 5. Refer to KFC’s Standard’s Library on cleaning instructions. (Continued)I

Model OFG- 3903-14. PREVENTIVE MAINTENANCEIf moving fryer to perform preventive maintenance:• Gas supply should be

Model OFG- 3903-14. PREVENTIVE Cleaning Blower Wheel - Annually MAINTENANC (Continued) The blower wheel

Model OFG- 3903-15. PROGRAMMING 1. Press and hold the FUNCTION button for two seconds.“REG PROGRAM” shows in the display, follow

Model OFG- 3908. After the proportional control, press and release theFUNCTION button. “ALM 1” and “TIME” flashes in the leftside

Model OFG- 390This manual should be retained in a convenient location for future reference.A wiring diagram for this appliance is

Model OFG- 3903-15. PROGRAMMING (Continued)Another product can be programmed while in the programmode by following thes

Model OFG- 3903-16. SPECIAL PROGRAM MODE (Continued) Factory Presets (F/C, Gas/Electric, Speaker Volume,Speaker Frequen

Model OFG- 3903-16. SPECIAL PROGRAM MODE (Continued) Tech I/O Mode1. Press and hold the FUNCTION button for two seconds

Model OFG- 3903-16. SPECIAL PROGRAM Heat Control MODE (Continued) 1. Press and hold the FUNCTION button for two sec

Model OFG- 390Power switch on but fryercompletely inoperativeShortening not heatingFoaming or boiling overShortening not draining

Model OFG- 3904-2. ERROR CODES In the event of a control system failure, the digital display shows anerror message. These mess

Model OFG- 3904-2. ERROR CODES (Continued)CE Only - Along with the error codes from page 4-2, CEunits have the following self-di

Model OFG- 390G L O S S A R YHENNY PENNY OPEN FRYERSair valve a valve on the eight head fryer that allows air into the filter lin

Model OFG- 390data plate a label or plate located on the right side panel of the fryer that indicates the fryertype, serial numbe

Model OFG- 390gas control valve an automatic dual controller that controls gas to both pilot lights and gas(gas fryers only) pres

Model OFG- 390Technical Data for CE Marked ProductsNominal Heat Input: Natural (I2H) = 26,4 kW (90,000 Btu/h) (Net)

Model OFG- 390power/pump switch a three-way switch located on the front control panel of the fryer that serves asan off/on switch

*FM05-031-G* Henny Penny Corp., Eaton, Ohio 45320, Revised 8-6-10Henny Penny CorporationP.O.Box 60Eaton,OH 453201-937-456-84001-937-456-8402 FaxToll

HENNY PENNY6 HEAD GAS OPEN FRYERSPECIFICATIONSHeight 61" (155 cm)Width 24" (61 cm)Depth 41¾" ( 107 cm)Floor Space Approximately 7 sq. f

TABLE OF CONTENTSSection PageSection 1. INTRODUCTION ...

Model OFG- 3901-1. INTRODUCTION The Henny Penny open fryer is a basic unit of food processingequipment. This unit is used only in

Model OFG- 390Henny Penny open fryer has may safety features incorporated.However, the only way to ensure a safe operation is to